Used TOYODA GL5-63II ANGLEHEAD CNC GRINDERS, REBUILT 2017
SCOPE OF REFURBISH:Completely disassemble, clean, and inspect the machine components.
Replace “plain head” wheel slide with rebuilt “angle head” wheel slide
The table and wheel slide guide ways will be scraped to restore "new machine" alignments. Turcite will be applied to way surfaces where required. If needed, the swivel table will be ground.
Re-establish centerline height between grinding wheel spindle, headstock, and footstock centers.
Refurbish Dead Spindle Workhead. Replace bearings, seals, and belts. Re-groove pulleys if required. Inspect servo motor, and make any required repairs.
Refurbish Footstock. Replace bearings, seals, and scraper. Rebuild ballscrew.
Refurbish Wheelhead. Inspect wheel spindle, bearings, and orifices. Clean spindle lube system, including reservoir, piping, etc. Replace spindle oil filter element. Replace drive belts. Repair or replace Wheelhead front way covers. Replace front rubber cover (over front way cover).
Refurbish Wheelhead Feed System. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Replace way wipers as needed.
Refurbish Table Feed. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Repair table way covers as needed. Replace rubber skirting. Replace way wipers as needed.
Refurbish Hydraulic/Lube System. Clean inside of reservoir. Clean and flush metal hydraulic lines and manifolds. Replace hydraulic hoses and tubing as required. Replace lube filter element.
Start up and verify function.
SPECIFICATIONS ARE SUBJECT TO BUYER INSPECTION
DISCLAIMER:The information and specifications listed on this page are believed to be accurate. Photographic representations are for illustrative purposes only, and may not be of the actual machine. International Machine is not responsible for any typographical or other errors that may exist.