Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center
Used 2000 Fidia K211 5 Axis Vertical Machining Center

Used 2000 Fidia K211 5 Axis

General Specifications

Fidia K211 with upgrade XP operating system, networked (machine is currently in service)

~ 53 HSK tool holders (drill chuck, collet, set screw and shrink fit)

End 1/2 yard hopper carts on each end

Bilz ISG-2000 shrink fit machine

Shrink fit machine stand

Tooling that mounts on the HSK holders

Hold downs (studs, step blocks, clamps)

Four riser blocks with cart (this raises the work piece as well as allows the work piece to be mounted vertical)

Stanley vidmar cabinet

Numerous drills and other tooling

Spade drills

thru the tool coolant adapter for introducing air and coolant for deep drilling

two gun drills that will allow for compound angle water lines

numerous collet sets

all books, service reports and notes

4 @ 2-4-6 setup blocks

4 @ 2-4-8 setup blocks

Omap HSK 63 calibration ball

Omap HSK 63 calibration bar

32 gig computer with dual monitor with surfcam

5-axis surfcam with custom post processor for the Fidia including 3+2 and true 5-axis programming

Steel work table with two drawers

Tool holder organizer

Bench vice

compression holder for changing HSK holders

floor mat

54538 power on

22192 spindle

 

SPECIFICATIONS ARE SUBJECT TO BUYER INSPECTION

DISCLAIMER: The information and specifications listed on this page are believed to be accurate. Photographic representations are for illustrative purposes only, and may not be of the actual machine. International Machine is not responsible for any typographical or other errors that may exist.


More from this collection